"MAKE A CIRCUIT" DIY KITS
The Make a Circuit Series is comprised by three different DIY electronic kits to introduce the “Wonderful World of Electronics” to kids and beginners.
Each kit includes all the parts you need to build a fun circuit and an 8-page comic in which fictional character Professor Scatterbrain explains step by step how to put the circuit together while introducing basic concepts in electronics.
To simplify the construction of the circuit, the kit includes laser-cut pattern that sits on top of the breadboard (assembling platform) and clearly indicates where each component goes.
The SONIC DRAWING Kit
Once the circuit is assembled, you’ll have a contraption that responds with different pitches when you draw with a pencil on a piece of paper.
The Kit includes,
- A color 8-page comic
- A 555 Timer Chip
- A 170 Tie Point Breadboard
- A laser cut/engraved Cardboard Assembling Pattern
- A 8 Ohms Speaker
- Two Alligator Clips
- Four multicolor Jumpers
- Two CR2032 Batteries
- A Battery Case with an ON/OFF Switch
- A 10 K Ohms Resistor
- A 100 UF Axial Capacitor
- A .01 UF Disc Capacitor
- And a Double Headed Pencil
LASER THEREMIN Kit
Once this circuit is assembled, you’ll have a contraption that responds with different pitches and changes the speed at which an LED blinks based on the light reaching the photocell included on the kit.
The Kit includes,
- A color 8-page comic
- A 555 Timer Chip
- A 170 Tie Point Breadboard
- A laser cut/engraved Cardboard Assembling Pattern
- A 8 Ohms Speaker
- Two CR2032 Batteries
- A Battery Case with an ON/OFF Switch
- A 470 Ohms Resistor
- two 10 UF Axial Capacitor
- A red LED
- A Photocell (light resistive sensor)
MUSICAL FINGERS kit
Once the circuit is assembled, you’ll have a contraption that responds with different pitches when you move your fingers, those wearing the Sensor Rings included in the kit.
The Kit includes,
- A color 8-page comic
- A 555 Timer Chip
- A 170 Tie Point Breadboard
- A laser cut/engraved Cardboard Assembling Pattern
- A 8 Ohms Speaker
- Two Sensor Rings with Terminals
- Two CR2032 Batteries
- A Battery Case with an ON/OFF Switch
- A .1 UF Disc Capacitor
- Four multicolor Jumpers
